VINYL APPLICATION PAGE 2

Same basic instructions as on Page 1, these are simply more designed for car windows or other curved serfaces.

©WhiteTigerLLC.com

W H A T  IT IS Premium Cast Vinyl  Film 2 mil premium grade, high performance cast PVC film. Designed for superior quality exterior graphics. Exterior durability up to 9 years.   Metallic vinyl films up to 5 year

Have clean surface prepared! Start by measuring & positioning decal on window, secure with auto masking tape layed out in a vertical line. This way you can apply half of the graphic at a time, starting from the center.

The decal will be visible thru the backing paper and should be right- read. SLOWLY separate and peel the protective backing paper from the transfer tape which carries the graphic. (keep a x-acto knife handy, as you may need it to help lift away edge of graphic from backing paper in areas)

Cut away exposed part of transfer film, (becareful because adhesive side of graphic is exposed and ready to stick!)

Slowly fold backing paper with exposed graphic back towards it's position on window and begin to lightly rub down vinyl EVENLY from CENTER, from top to bottom until you reach the end. This is your big opprtunity to avoid bubbles and creases by going   SLOWLY and applying EVENLY!!!

Rub down firmly with fingers. Final rub down will be with    a med to hard plastic squeegee after entire vinyl decal is on the window.

With the left side now stuck to window, you can now remove masking tape. Fold back other side and begin removing backing paper

SLOWLY and carefully begin rubbing down FROM the CENTER the remaining graphic.

Now use your squeegee to slowly but firmly burnish graphic onto window, so that transfer tape will   separate from graphic.

SLOWLY pull away remaining transfer tape at a sharp angle, (because it will want to resist!)

Finishing Touches:

You may get a bubble no matter how slow or careful you are. Not to worry! Prick the bubble with a pin or x-acto knife with surgical precision.

Use left-over piece of backing paper to shield your vinyl from direct contact with squeegee to rub out bubble or even out crease.

You now have a hot graphic on your hot pony!

PREVIOUS INSTALL PAGE

Please be aware, once we ship a Vinyl Graphic the rest is up to you. We are not responsible for any damage you or anyone else may do to the graphic. If you feel you are unable to follow these instructions and may not be able to properly apply this graphic, please seek out the help of a professional vinyl graphic installer. We assume no responsibility for this once it leaves our shop. Thank you for your cooporation and understanding.

IF YOU HAVE ANY QUESTIONS PLEASE EMAIL US BEFORE APPLYING YOUR GRAPHIC

HOME PAGE